|
Walk-in panels shall be modular tongue and groove and constructed of precision roll-
formed metal covering and 100% injection molded polyurethane. Polyurethane foam exhibits
the best strength and characteristics in the inducstry today witha foam density of 2.3
lbs per cubic ft. The panels shall be a thickness of 2", 4", 5", 6", or 8" with an
R-factor of R-8 per inch. Our standard widths are 11½", 23", 34½", and 46"
in continuous lengths of up to 29' 10". All panels are connected with cam-lock fasteners
not to exceed 34½" between each cam.
Panel seam P-Gaskets are USDA and NSF approved vinyl and they shall be injection molded inplace
at ht time of manufacturer. Available in PBC silicone with butyl or contact adhesive:
- 26 or 24 gauge galvanized steel, embossed
- 26, 24 or 22 gauge white galvanized steel, smooth or embossed
- 26 or 24 gauge white PVC coated galvanized steel, smooth
- 22 or 24 gauge stainless steel, #4 polish
- .040 embossed alumninum
- .040 white aluminum, smooth or embossed
- 26 gauge galvalume with 1 mil polyester baked on finish
Floor panels are available in 100% injection-molded polyurethane and in thickness of up to 8".
Advance floors can be internally reinforced to sustain loads of up to 4,800 lbs per sqaure foot
(PSF), while maintaining 80% of all thermal properties. Floor drains are foamed in place and
recessed into the panels.
- 16 gauge G90 galvanized steel 650 PSF, standard
- 14 gauge G90 galvanized steel 800 PSF, standard
- 16 gauge G90 galvanized steel with reinforced plywood 1,000 PSF
- 14 gauge G90 galvanized steel, reinforced with PVC tubing to withstand up to 4800 PSF
- 14 gauge galvalume
- Single-ply rubber membrane with aluminum trim
|
